| Page 1 of 1 |
|
|
 Posted: Tue, 17th Feb 2009 19:29 Post subject: Sleep Mode |
|
 |
after changing case/psu pc getting in to sleep mode but all the fans are still spinning, could it be coz psu has only 20pin atx connector instead of 24?
if yes will 20 to 24 pin convertor will do the job or psu needs to be replaced?
same pc config, same Vista x64, only different psu
any ideas?
|
|
| Back to top |
|
|
LeoNatan
☢ NFOHump Despot ☢
Posts: 73194
Location: Ramat Gan, Israel 🇮🇱
|
| Posted: Tue, 17th Feb 2009 22:04 Post subject: |
|
|
24-pin PSUs were introduced for graphics card and HDD stabilization, and it is generally recommended to use 24-pin PSUs. Converters, from what I have read on other forums, cause even more instability issues. If the PSU has only 20 pins, it is probably very old, and you should replace it with a good one.
That said, I don't believe the sleep issues are caused by the PSU. Try playing with the hybrid sleep option in the power options, maybe it has something to do with it.
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Sun, 22nd Feb 2009 20:38 Post subject: |
|
|
figured it out it was usb mouse that was preventing sleep, had to uncheck in power management allow this device to wake the computer
|
|
| Back to top |
|
|
LeoNatan
☢ NFOHump Despot ☢
Posts: 73194
Location: Ramat Gan, Israel 🇮🇱
|
| Posted: Sun, 22nd Feb 2009 21:13 Post subject: |
|
|
Hmmmmmm I will do that for my mouse as well. Sometimes I accidentally push my desk and my G9 (ultra sensitive) wakes the PC up.
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
| Page 1 of 1 |
All times are GMT + 1 Hour |
