| Page 42 of 111 |
|
|
|
| Back to top |
|
 |
|
|
|
| Back to top |
|
|
JackQ
Non-expret in Derps lagunge
Posts: 14179
Location: Kibbutznik, Israel
|
 Posted: Mon, 29th Aug 2011 12:01 Post subject: |
|
|
same here,been told numeros times about the "almost unhackbliliy" of the box,that only the Drive left has the weak spot...
"Fuck Denuvo"
Your personal opinions != the rest of the forum
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 13:09 Post subject: |
|
|
The reason Xenons aren't supported is because the hack makes use of the 360's HANA chip (HDMI) whereas the Xenon only had the ANA chip. As best as I can tell.
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 14:12 Post subject: |
|
|
So that means very old 360's without HDMI cannot do this?
“The only way to deal with an unfree world is to become so absolutely free that your very existence is an act of rebellion.”
- Albert Camus
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 14:19 Post subject: |
|
|
There's a booming market for Xenon JTAGs with reballed chips and 12v fans. Amazingly, once reballed and with better cooling, they last quite a while.
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 14:38 Post subject: |
|
|
I can't decide if i want to buy the tools now, or wait for a task-specific modchip like device to come out. I mean, a JTAG programmer could potentially have some uses in the future aside from just xbox hacking, right?
I guess its kind of moot until there is a workable solution to actually run games.
i7 5820k @ 4.4 || MSI X99S XPOWER AC || Samsung XP941 256GB M.2 SSD || G.SKILL Ripjaws 4x4GB 2666 DDR4 || Gigabyte GTX 970 GAMING-4GD || Dell 2407 || Razer Blakcwidow Ultimate || Logitech G502
|
|
| Back to top |
|
|
Grale
Banned
Posts: 3321
Location: Invert
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 15:57 Post subject: |
|
|
If this isn't available as an easier method by December, I'll just buy a Falcon JTAG from ddsdavey once I return back to the UK for Christmas. I'd buy one now, but getting the machine through customs would cost me almost as much as the cost of purchase itself.
|
|
| Back to top |
|
|
Grale
Banned
Posts: 3321
Location: Invert
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
Grale
Banned
Posts: 3321
Location: Invert
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 16:11 Post subject: |
|
|
"Almost" tempted. I'm not going to, I'll grab a Falcon once I'm back in England - or if this hack has been made easier I'll just use my existing Jasper-512. Oh and in regards to your edit; it's to run software. The hack is done via HW, but it has a 25% chance of launching the software each try - ie, XeLL, but once it's launched it's done until you turn off your machine again.
I can deal with a +/- 2 minute launch time. I've got an iPod Touch and that fucking piece of crap takes EASILY 2 minutes to boot.
|
|
| Back to top |
|
|
Grale
Banned
Posts: 3321
Location: Invert
|
| Posted: Mon, 29th Aug 2011 16:17 Post subject: |
|
|
Ahh if it's launch Xell/Freebot then that's cool. turn it on make a brew or open a beer and good to go.
MSI X570 Tomahawk |Corsair Vengeance LPX 32gb 3600mhz | Ryzen 5800X3D | EKWB Watercooling | Seasonic Focus GX 850 Gold PSU | 4090 Founders | Predator X34P UW curved monitor | Window Pro 10 x64
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 17:57 Post subject: |
|
|
I'm not sure how easy its going to end up being, unless they figure out a way to modify the firmware directly on the NAND instead of dumping it, inserting the payload on your PC, and reflashing it. Even if the do figure out a way to do it directly, you will still need to solder on the JTAG programmer, in addition to the FPGA that needs to stay soldered onto the xbox for the attack itself.
i7 5820k @ 4.4 || MSI X99S XPOWER AC || Samsung XP941 256GB M.2 SSD || G.SKILL Ripjaws 4x4GB 2666 DDR4 || Gigabyte GTX 970 GAMING-4GD || Dell 2407 || Razer Blakcwidow Ultimate || Logitech G502
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 18:40 Post subject: |
|
|
I've thought about that but E-bay is cracking down on Jtag sellers.
True Story. I bought one from a guy on there and tried to re-list the item.
They pulled the auction.
I ended up selling it local so no loss but Fleabag is right. That whole site has changed.
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 18:45 Post subject: |
|
|
Oh. Your Xenon is already JTAGed... sorry mate. Since eBay is cracking down, stick it on Xbox-Scene or something?
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 19:26 Post subject: |
|
|
I have a Xenon jtag machine. Its still good and working fine. But at this point of time I am little confused. Should I buy a new slim model or stick to my old one.
BTW is the new slim models are immune to RROD? If so which model?
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
|
| Back to top |
|
|
|
|
| Posted: Mon, 29th Aug 2011 19:32 Post subject: |
|
|
My Jasper was made in 2009 and was owned prior to me, still going strong =)
|
|
| Back to top |
|
|
| Page 42 of 111 |
All times are GMT + 1 Hour |
