NFOHump.com :: View topic - [XBOX] Flashing Liteon: Warning Serial Data Bad Error

Page 1 of 1

dougiej2004

Posts: 433

Posted: Wed, 18th Mar 2009 20:49 Post subject: [XBOX] Flashing Liteon: Warning Serial Data Bad Error	Quick Quote Quote

ok basic setup, windows xp,via raid card 6421,drivers for via and ioport and usb drivers for ck3,ck3 pro and probe, using usb instead of serial cable,basically for some reason my probe is always lit green even before contact on r707 bridge,so anyway done a million half tray methods which everyone says try this it works bla, trying to flash stock liteon to 1.51 xtreme using jungleflasher, connect my probe to the r707 bridge and hit get key,but get this warning serial data is bad!! been driving me mad for 4 hours now,all i get in ck3 tool is invalid key

Rabowke

Posts: 216

Posted: Thu, 19th Mar 2009 08:03 Post subject:	Quick Quote Quote

try to boot into 'dos' and use 'native' dos tools. i had to done it so cause i was unable to erase my firmware under xp, so i need dos tools. before i flashed my 'new' 360 i readed a lot in forums etc. and many people say, if you had trouble to do it under xp, try dos so my advice: try it

Mutantius
VIP Member

Posts: 18594
Location: In Elektro looking for beans

Posted: Thu, 19th Mar 2009 10:15 Post subject:	Quick Quote Quote

Remember to use the correct COM port. "Why don't you zip it, Zipfero?" - fraich3

dougiej2004

Posts: 433

Posted: Thu, 19th Mar 2009 12:12 Post subject:	Quick Quote Quote

course im using correct com port,if i try it in ck3 tool i get invalid key,and if i do it in jungeflasher i get warnign serial data bad,what is the dos method?

Glottis
Banned

Posts: 6313

Posted: Thu, 19th Mar 2009 12:25 Post subject:	Quick Quote Quote

c4eva (dev of iXtreme and jungleflasher) specifically told everyone to avoid using VIA. C2D E6750 @ 3.2Ghz, 4GB 800MHz DDR2 4-4-4-12, GeForce GTX 260 c216 OC 896MB, 3.2TB, Windows 7 Ultimate x64 Xbox 360 Elite, PS2 Slim, Xbox

dougiej2004

Posts: 433

Posted: Thu, 19th Mar 2009 12:30 Post subject:	Quick Quote Quote

well i think my problem is the ck3,as my probe is always green from minute usb power goes in,

Mutantius
VIP Member

Posts: 18594
Location: In Elektro looking for beans

Posted: Thu, 19th Mar 2009 12:38 Post subject:	Quick Quote Quote

What USB port do you use front of the case? or directly into the motherboard? "Why don't you zip it, Zipfero?" - fraich3

dougiej2004

Posts: 433

Posted: Thu, 19th Mar 2009 13:21 Post subject:	Quick Quote Quote

tried front of the case,and back of the case

Page 1 of 1

All times are GMT + 1 Hour