Hello my fine connaiseurs...
First of all, mods please merge this thread if something similar exist as a thread somewhere. I have to admit, I did not search.
My question is pretty simple and maybe some of you have a similar setup that could help me decide on how to set this up.
I just bought the Lian-LI XL full tower.
I am switching from the 3950x to the 5950x using my same board, MSI Meg Ace X570.
I also bought a 360 rad AIO to go with this and 6 Noctua fans 120mm.
I have a single Corsair ML 120 or 140 cant remember that goes on the back side and unfortunately I have a 200mm Noctua that I probably wont be able to install in this new case.
Now, what would be the best push/pull setup to maximize the airflow and keep decent temps at the same time.
Also, I have the 3090 which I am not sure if it is relevant to the setup I need, unless it would be better for it to be installed sideways instead of the usual flat horizontal way.
Yes I can look at youtube videos and all and there is a shitload of them but I rather have a direct opinion of someone in here that actually has a similar setup or very good knowledge about it.
Room temps are a steady 20-21 degrees celcius and the case is on a 3 foot high square hard wooden table.
Thanks and sorry for the long post. 
Lian-Li XL Dynamic ROG Black - EVGA 1000w - Lian-li Galahad 360 AIO - MSI X570 Meg Ace - Rysen 5950x - G.Skill 4x16GB CL14 3600@3800(14-15-15-34) - Samsung 960 Pro 512 - Samsung 960 Pro 1TB - Kingston HyperX SSD 120gb SATA 3 (6gb/s) - WD Black Caviar 2x 2TB SATA 3 (6gb/s) Raid 0 - WD Black Caviar 2 TB SATA 3 (6gb/s) - EVGA 3090 FTW3 - LG C1 48" 4k120hrz
